cisco 7200 simulation, dynamips,Dynagen,GNS3,PEMU,

Installing Cisco IDS on VMWare

Installing Cisco IDS on VMWarewe can now install Cisco IDS on VMWare ver 5.5.3.
Virtual machine installation points:
After configured three NIC, do not start vmware immediately. Close vmware, find virtual machine configuration files generated by vmware (.Vmx files), open the edit, find
ethernet0.present = “TRUE” add a line underneath
ethernet0.virtualDev = “e1000″
Adding this line is to make vmware simulate e1000 NIC.
As to other NIC, ibid.
——————————————

Hardware preparation:
??
??a PC, requirement:
??Mainboard: 440BX main-board is best, of course, you can use others, but it should at least support 440BX, VIA686a; AMD chips.
??CPU: basically unlimited, PII above is ok, the higher the better. We suggest 600MHz frequency above; At least support Athlon 1.7.

??RAM: 256M – 4G? suggest 512M above
??HD: ordinary IDE drive is ok. Of course, some common SCSI can also be used, and it seems to support iSCSI NIC, too: the only requirement is to prepare at least two NIC, and at least one of them must be 100M (EEPro100 various types) or 1000M (EEPro1000 various types) Intel NIC according to model differences you want to create;

??The chipset can be Intel82557/82558/82559/82550 and so on. (It may also support Broadcom BCM5700) this Intel NIC is used as a monitor, thus it should be plugged into PCI slot, or at least preceding the second block on PCI. In this way it will be considered as ETH0 in the system, while ETH0 is the default system monitoring interface, which should be Intel NIC.

??Theoretically, another card could be any chip card that Linux 2.4 kernel can support, but we will also recommend you use Intel EEpro100. in this way we can avoid a lot of troubles or unnecessary mistakes. This card will be considered ETH1in the system, used for management and communication.

??the following is my configuration:
??AMD Athlon XP 1700+
??1G RAM
??160G IDE or LSI 160 SCSI (both support)
??Default monitoring interface

High quality Cisco, Microsoft, IBM, Oracle,Microsoft,Citrix,Vmware,HP,Juniper and other Certification exmas training materials are provided here at PassGuide Site

Download Free Cisco Dynagen Simulation Certification Braindumps

1. Free VMWare Certified Professional Update – VCP
2. Free VMWare ASA AIO virtual Image
3. Free Install Junos 8.0R1.9 on Vmware 5.5.3
4. Free 3 x JUNOS na VMWare = DynaJUN :P
5. Free 3 x JUNOS na VMWare = DynaJUN :P
6. Free install CS-MARS 20 on vmware
7. Free free crack testking vmware vcp-301 v25 pda
8. Free Run course of Cisco IPS on VMWare[3]
9. Free running IPSv5 on VMWare
10. Free Run course of Cisco IPS on VMWare[1]